Skip to content
  • There are no suggestions because the search field is empty.

IB Metal Corner Transition

IB Clad Drip Edge is formed into a standard metal drip edge profile to provide heat-weldable perimeter roof edge termination for IB roofs. After the IB Clad Drip Edge has been installed at the corner, complete the installation by placing a strip of two-inch wide IB Foil Tape, so it is centered over the roof-to-wall angle change. Then, cover the IB Foil Tape with an IB NR five-by-eight Metal Joint Patch, so it is centered over the roof-to-wall angle change.

Weld the IB NR Metal Joint Patch to the exterior face of the IB Clad Drip Edge. Trim any excess material off of the IB NR Metal Joint Patch and round the corners. If applicable, install an additional piece of IB NR Metal Joint Patch to complete this step. Roll out the IB Cover Strip to the desired length and cut. Make sure to round the corners at each end.

Position the IB Cover Strip one-quarter inch off of the exterior edge of the roof. Weld the roof edge side of the IB Cover Strip, first turning up the wall and continuing to weld the Cover strip to the clad metal on the vertical of the wall. Complete the installation by then welding the interior seam of the IB Cover Strip to the field membrane. Ensure that all welded seams form a one-and-a-half-inch weld. Upon completing the installation, ensure all seams and laps are inspected and probed. If deficiencies are found, the area must be re-welded or repaired.

 

Ready to Discuss Your Project?

Are you a commercial building owner or property manager and have some questions about products or specifications? Let us know and one of our team members will be in touch to help answer your questions.

Review my Project